Samsung Q25 Getting Started page 115

Docking Station Related
Q1 I cannot replace the docking device when the system is in
Standby or Hibernate mode.
A Since removing a docking device when the system is in Standby or Hibernate
mode causes the system to become unstable, the remove operation is not support-
ed when the system is in this state. Please remove the docking device after the
system is no longer in Standby or Hibernate mode.
Q2 The Undock button does not work properly.
A1 When the system is turned on, you can release the docking station only if the
remaining battery charge has more than 10 % capacity left.
A2. Since a docking station requires a configuration time after pressing the Undock
button, first wait a short while before separating the docking station.
Q3 A 'USB device recognition failure' error message appears.
A This error may happen when removing a docking device when the system is in
Standby or Hibernate mode. Please only remove a docking device when the sys-
tem is no longer in Standby or Hibernate mode.
Q4 Multiple CD drives appear in the My Computer window.
A This is a known problem in the Windows XP operating system. This may happen
when a 1394 bus driver searches for a storage device. This problem is scheduled
to be fixed in Service Pack 2.
Q5 I have connected a Samsung USB 2.0 HDD (Handy Q) to the sys-
tem through a USB 2.0 hub when the docking station is
installed, but the system does not recognize the storage device
properly.
A Please connect the Samsung USB 2.0 HDD (Handy Q) directly to the USB port of
the system or the docking station.
Q6 A 'Delayed write failure' error message appears.
A This error may happen when you have an auxiliary hard disk drive installed in
the docking station. Since thiserror may happen when the file system of the hard
disk is NTFS, format an auxiliary hard disk drive as FAT32.
Chapter 7. Recovering the Computer 7-25