Table of Contents
Advertisement
Q7 I pressed <Fn>+<
A This problem may occur when you pressed <Fn>+<
play devices while there is no external display
device connected.
Connect an external display device first, then convert display devices.
Q8 When I pressed <Fn>+<
the screen resolution is changed.
A Change the resolution again on [Graphics Controller Properties] dialog. (Refer to
'Using External Display Devices' (P. 6-8).)
Q9 When I changed display properties setting and restarted the
computer, the property is converted to the prior setting.
A Change the setting on [Display Properties] dialog and apply immediately without
restarting the computer.
Q10 When I played a DVD or an MPEG file while the display is set
to Dual Display Clone, the video file is interrupted while play-
ing or displayed only on one display device.
A1 Set the display to Dual Display Clone as follows, then play a DVD or an MPEG
file.
1. Press touchpad right button on the desktop.
2. Click Graphic Options > Graphic Properties > Devices tab.
3. Select Dual Display Clone, then select 'Same display configuration driven on
both displays' check box.
4. Click OK.
A2 If above methods do not solve the problem, change the setting to display only on
the LCD.
Q11 <Fn>+<
> keys do not operate.
A When you are playing a video file such as a video CD, an MPEG file, or a DVD,
when no external display is connected, or when you are using the extended
desktop mode or full screen DOS mode, you cannot change display devices.
> keys, then the screen blinks.
> keys to change display devices,
Chapter 7. Recovering the Computer
> keys to convert dis-
7-11
Advertisement
Table of Contents
