SafeLife Go Anywhere Instruction Manual page 6

Breakdown:
FL1, The1 st digit (1) means you want to turn the falls detection on.
(To turn falls detection off enter a (0) and send the text message. i.e. FL0)
nd
FL1,2 The 2 digit (2) being the sensitivity. 1 being most sensitive and 10 being least sensitive.
rd
FL1,1,0 The 3 digit is to turn on & off the dial out function for the falls detection.
(Refer to notes on "Call Out procedure")
Setting up a Geo Fence
You may set up a Geo Fence. This means that if the radius boundary is broken the device will alert
the emergency contacts. Perfect for wandering residents. Please note you must be in the centre of
your set radius boundary with the device when setting this function.
Example command:
Breakdown:
st
Geo1 The 1 digit (1) is the first Geo fence you are setting. You can set up to 4 Geo fences.
nd
Geo1,1, The 2 digit (1) is to turn the Geo Fence on.
rd
Geo1,1,0, The 3 digit (0) is to set the Geo fence to alarm when it leaves or enters the pre-set area.
(0=leave, 1=enter).
Geo1,1,0,100m The last part of the command is the radius distance you want to set the Geo Fence
to. To avoid false alarms the recommended minimum radius is 100 meters.
Geo fence can be set in meters or kilometres i.e. 100m or 50km.
Find Me – Misplaced your Pendant?
Texting the word "findme" to your pendant will make it sound the message "Hi! I'm here".
The Find Me feature does not work if voice prompts have been turned off. To cancel the
announcement once found, press the SOS button.
Command: 123456findme
Turn Voice Prompts On/Off
You can disable the voice prompts by quickly double pressing the lower side button. The pendant will
respond "Voice tone has been turned off (or on)".
Making a Phone Call and Receiving Incoming Calls
st nd
Your 1 or 2 emergency contact will be assigned to the side call 1 button (top side button). To call
this contact, hold down the top button on the side of your device. Once the pendant has dialled the
number, you can cancel this call by pressing the SOS button.
Note: this function will only work if the emergency contact is programmed to receive not just the SMS
message but also the call out when the SOS button is pressed (Important see notes on "The Call Out
Procedure" before progressing)
If you want to change this to call a different contact, replace the first 2 with another contact location as
in the in the following example.
Command: 123456x2,20
Example i.e. Change the side button to call contact number 1.
To disable the side call button
Adjusting the time
Google UTC time in your state and add the required hours to bring the pendant's time to the current
time. Note: Incoming text messages are also time stamped by your mobile phone.
Command: 123456tz+10
123456Geo1,1,0,100m
Command:
This will add 10 hours to the UTC time.
(1=on, 0=off)
Command:123456x1,20
123456x0
(1=on, 0=off)
(0=off, 1=on)