Product Overview - SafeLife Go Anywhere Instruction Manual

Product Overview

Thank you for using the 4G SafeLife Pendant. This device is an innovative miniature size personal
emergency pendant with built-in GPS, Bluetooth and WiFi positioning technology and waterproof to
IP67. The SafeLife Pendant is for monitoring and protecting vulnerable people at any age with a
medical condition. This product requires an active SIM card and operates on the 4G Telstra network.
The user must check they have adequate coverage in their area. The SafeLife Pendant should be
tested regularly. It should not be considered a life saving device but with due care and diligence it
offers an important aid to the well-being of the wearer both at home and away from home. When first
turned on it will take a couple of minutes before the pendant can establish its GPS position and you
may need to go outside for best results. If a GPS position cannot be obtained it will fall back and
report the position of the strongest obtainable WiFi location. A WiFi location is usually less accurate
than a GPS determined location. However, if the docking hub is programmed with your home co-
ordinates, this will be the first point of location when in range of the pendant (for accurate location
when in the home).
Important Note:
When you program your emergency contacts you can choose if each contact will receive the text
message only (with GPS location) or if the pendant will make a phone call to that number also.
Because of the complication of voice mail boxes, we generally suggest for the device not to dial out.
This will also free the pendant up to allow any one of the emergency contacts to immediately call into
the device, quickly placing them in voice contact with the user. For more details see the section on
"The Call Out Procedure".
Turning on/off the Pendant
Simply holding down the top button on the left side of the device or charging the pendant will turn the
device on. The device may take a moment to power up.
To turn off press and hold the SOS button followed by the top side button a half second later until the
device vibrates - then release the buttons.
Please Note: For security purposes keep the IMEI &SIM numbers confidential
Charging the Pendant
The Docking station will also recharge the devices battery. You may connect the dock to the USB port
on your home computer or use the supplied plug pack to connect to a 240v power point. As the
pendant is placed in the dock it will make the announcements "Charging".
Getting a GPS Fix
Depending on the environment, when the device cannot get a GPS positioning it will rely on WiFi
which is less accurate. Alternately if you have set up your docking hub with your home co-ordinates,
your pendant will use this as the first location point as long as it is in range and has Blue Tooth
connectivity to your docking hub.
Inserting the SIM Card
The Safe Life Pendant requires a Mini SIM card on the Telstra Network. Depending on where you
have obtained your pendant the SIM card may have been supplied and installed. It will not work
without a SIM card.
To insert the SIM card:
1. Turn the pendant off by pressing and holding the SOS button followed by the top side button
a half second later until the device vibrates.
2. Unscrew the back cover with the screw driver provided and gently lift the cover exposing the
circuitry.
3. Gently insert the SIM card and slide the retaining cover forwards locking the SIM in position.
4. Put thecase back into position. Be careful not to over tighten the screws and damage the
housing.