Advertisement
Quick Links
The WattBox network management card gives you internet control over your
WattBox non-IP UPS products.
ANATOMY
Ethernet port (to network)
Œ
Ethernet port (to UPS)
Ethernet port status LEDs
Ž
Pin Jumper
PORT STATUS LED KEY
Green LED (Ethernet bandwidth)
On: Port is operating at 100Mbps
Off: Current web bandwidth is 10Mbps
Yellow LED (link status)
Flash: Link Active
Off: Card is not connected to the network
™
WB-UPS-NMC
Ž
Quick Start Guide
Œ
Advertisement
Summary of Contents for WattBox WB-UPS-NMC
- Page 1 ™ Quick Start Guide WB-UPS-NMC The WattBox network management card gives you internet control over your WattBox non-IP UPS products. ANATOMY Ethernet port (to network) Œ Ethernet port (to UPS) Ethernet port status LEDs Ž Pin Jumper ...
- Page 2 INSTALLATION CAUTION: This card is not UL certified. Be sure to ground yourself before installation, and only handle the card by its face plate! 1. Remove the cover from the Intelligent Slot on the back of your UPS. Save the screws for securing the SNMP card.
- Page 3 CONFIGURATION Install the SNMP web manager software (available on the product web page at SnapAV) onto your PC. Run the program. You’ll see the interface below. In the search box (circled) you can enter a partial or complete IP address to search for matching devices in the network.
- Page 4 If you need help, email support@SnapAV.com. For information, instructional videos, support documentation, or ideas, visit our website. This WattBox™ product has a 3-Year Limited Warranty. This warranty includes parts and labor repairs on all components found to be defective in material or workmanship under normal conditions of use.