Advertisement
5. CONTROLLING THE HARDWARE
<Diagnosis>
When the raidctrl command finishes normally, it returns exit code 0.
If the command returns abnormally, one of the error messages listed in Table 5-3 is
displayed, and the command returns an exit code other than 0.
No.
Error message
1
Usage:raidctrl [/NOTIFY [{ON|OFF}]]
2
Invalid argument. (%1)
3
An error occurred in %1. errorcode
= %2
4
You do not have the privilege to execute
this command option.
Please execute this command option
again on "Administrator: Command
Prompt".
5
Access denied.
Log on console session,
And execute this command option again
on "Administrator: Command
Prompt".
6
raidctrl: This function was executed on
a non-RAID model.
Table 5-3 Error Messages of the raidctrl Command
There is an error in the specified options.
Specify correct options.
Specified option %1 is not correct.
An unexpected error (%2) occurred in the function (%1).
Retry the command. If the same error message persists,
restart this equipment.
You do not have administrator privileges.
Log on to the computer using an administrator account
and run the command again. If User Account Control
(UAC) is enabled, start the command prompt with
administrator privileges and run the command.
You cannot use this command with this option from a
remote session.
Log on to a console session and run the command again.
If User Account Control (UAC) is enabled, start the
command prompt with administrator privileges and run
the command.
The command is executed on a model other than D
Model.
This command can be executed on D Model only.
5-8
Description
Advertisement
