18
EN
valve turned to high.
Burners burn with yellow
smell of gas.
Burner will not light with the
igniter, but will light with a
match.
Burner will not stay lit when
control knob is released.
www.napoleongrills.com
procedure.
line.
Possible spider web or other debris.
Loose electrode wire or switch
terminal wires.
Knob not being held in long enough.
Too windy.
thermocouple from being fully
Dirty thermocouple or thermocouple
Normal occurrence on hot days.
Lack of gas.
Supply hose is pinched.
tube.
turned on. Turn tank on slowly to
Thoroughly clean burner venturi. See general
terminal on the back of the igniter. Check that the lead
wires from the module to the
release
Unit will shut down if winds are greater than 10mph
is less windy.
and that the small hole below the thermocouple is
unobstructed.
between the valve and thermocouple. Ensure the
Replace thermocouple and / or valve.
This is not a defect. It is caused by internal
performance or safety of the gas heater.
Check gas level in propane cylinder.
Clean out venturi tube.
is turned on. Turn tank on slowly to allow pressure to
N415-0390 MAY 09.18