Nags Head Hammocks Deluxe Double Swing Assembly Instructions

Deluxe Double Swing
Congratulations on your purchase. You now have one of Nags
Head Hammocks' innovative products! If you have any ques-
tions regarding this product, we invite you to call us 7 days a
week at 800-344-6433.
Helpful tips before starting: • Get someone to help you. Some
pieces are heavy and a second pair of hands always helps. •
Do not tighten the bolts completely until the product is fully
assembled. Some pieces are harder to fit in place and this will
help. A hammer or rubber mallet is needed during assembly.
• Do not over-tighten the bolts or screws. • The photos in our
product catalog can provide additional help while assembling
your item. • Build your item close to where it will be used to
eliminate difficulty in moving once completed. • For a uniform
look, face all nuts in the same direction.
Swing Parts
Back Table Legs
Right Arm
Cup Holder
Table Top
Hardware
Step 1. Align left arm with swing body. Insert 3.5" hex bolt through
washer, through arm and swing body. Secure using washer and nut. Use
this same process for all three holes. FIGURE 1
Step 2. Repeat Step 1 for right arm.
Rollup
Front of Rollup
Left Arm
Cup Holder
7 - 5" x .25" Hex Bolts
8 - 3.5" x .25" Hex Bolts
30 - .25" Washers
15 - .25" Lock Nuts
4 - 4.5" x .25" Button Head Cap
6 - .75" Barrel Bolt Assemblies
2 - Tree Hooks
2 - Chain Assemblies
2 - 4"x.25" Button Head Cap
1 - Allen Wrench
FIGURE 1
Step 3. Lay upper body rollup to front of swing as shown. FIGURE 2
FIGURE 2
Step 4. Attach left outside upright with 3.5" hex bolt in bottom hole,
making sure washers are touching both sides of upright. Secure with
nut. FIGURE 3
Step 5. Using a 4" button head bolt in upper hole, secure left outside
upright. FIGURE 4
FIGURE 4
Step 6. Repeat Steps 4 and 5 for right outside upright.
Step 7. Attach front table legs using 5" hex bolt and washers. make sure
angle of feet matches photo. FIGURE 5
FIGURE 5
FIGURE 3