Download Print this page
Nags Head Hammocks DELUXE BENT OAK PORCH SWING Manual

Nags Head Hammocks DELUXE BENT OAK PORCH SWING Manual

Advertisement

Quick Links

INSTALLATION :
Install the ceiling hooks in the overhead support. The hooks should be approxi-
mately 5 feet apart. The supports can be ceiling joists, a sturdy limb, or a beam
installed for the swing. Ready made stands or instructions to build one are avail-
able, please inquire. If the ceiling joists are not exposed, locate one using a stud
finder. They are usually 16 to 24 inches apart. Once you find a suitable support,
drill a 3/16" starter hole to screw the ceiling hooks into and tighten until the
shank is no longer visable. Do not adjust the chains as they are properly connect-
ed and able to withstand approximately 500 lbs. of weight. We have replacement
chain sets available for sale if replacement needed.
MAINTENANCE :
The rope body of your Bent Oak Rocker is hand woven. If the weave of the rope
body is pulled out of shape, you can brush or adjust it into shape with your hands.
To keep your bent oak swing in good condition, it is very important to consistantly
check the varnish for weather damage. The wood frame should be periodically
refinished using a high quality polyurethane varnish. For complete instructions
on refinishing your swing, please visit www.nagshead.com/care.asp, or give us a
call. To wash the rope seat, you can either leave the ropes attached to the chair
Before removing the ropes from the wooden bars, slide
or remove them.
guide ropes through the topmost and bottommost row of loops, and
tie them off.
You will need OxiClean or laundry detergent and a soft scrub brush.
To begin cleaning, wet the rope and apply the detergent. Additionally, you may
use a very mild bleach solution, but be sure to rinse the ropes thoroughly after-
wards. Take a handful of rope in each hand and rub the pieces together; using the
soft-bristled scrub brush to work on any stains. Once you've cleaned all of the
rope, rinse it thoroughly. If you have removed the rope from the chair, arrange it
on a flat surface to air-dry so that the rope does not stretch.
If you have any questions about maintaining your chair, please give us a call at
1-800-344-6433 or 252-441-6115
WARRANTY AND RETURNS :
Nags Head Hammocks products are guaranteed to be free of defects in both work-
manship and material. Prolonged exposure to weather conditions including snow,
rain, and humidity are not covered under the warranty, nor is damage caused by
normal wear, mildew, or improper care, including storage, maintenance, and as-
sembly. If you are not satisfied with an item, return it unused in its original pack-
aging for a complete refund or exchange. You can return it to any of our stores
or to our warehouse, Nags Head Hammocks, 305 Industrial Blvd., Greenville, NC
27834. Please include a copy of your receipt and your contact information.
Instruction #: 5065NH, 0G.11
DELUXE BENT OAK
PORCH SWING
Congratulations! You now own a Deluxe Bent Oak Porch Swing that was
handcrafted in North Carolina by Nags Head Hammocks. We hope you will
have many years of comfort and enjoyment. If you have any quesitons,
please feel free to contact us. Relax! It's a Nags Head Hammock original.
P.O. Box 533
Nags Head, NC 27959
1-800-344-6433
www.nagshead.com
252-441-6115

Advertisement

loading

Summary of Contents for Nags Head Hammocks DELUXE BENT OAK PORCH SWING

  • Page 1 WARRANTY AND RETURNS : Congratulations! You now own a Deluxe Bent Oak Porch Swing that was Nags Head Hammocks products are guaranteed to be free of defects in both work- handcrafted in North Carolina by Nags Head Hammocks. We hope you will manship and material.
  • Page 2 Step 2 : Take a loose bar and insert a 4” hex head bolt through a washer before PARTS LIST : pushing it through one of the holes at the end of the bar . Position this bar in- 1 Roll-Up Unit : The “top” bar of the roll-up features a thin wooden strip with side of the arm unit, put the end of the bolt in the hole, and then push the loose brass tacks.