JVC HD-ILA HD-65S80DDU Instructions Manual page 9

Install the NEW lamp unit
4
1
Unpack
Do not drop the lamp!
Do not shock the glass
surface of the lamp!
It may shatter the lamp causing injuries. It may shatter the lamp causing injuries.
2
Insert
Make sure the lamp sits securely
and flat in the housing area.
3
Reinstall the lamp cover
Tighten the screw.
5 Plug in the TV
Never touch the
glass surface of the
lamp!
Oils deposited from the finger may Oils deposited from the finger may
cause a difference in temperature cause a difference in temperature
when the lamp heats up to its when the lamp heats up to its
operating temperature, causing operating temperature, causing
the lamp to break. the lamp to break.
Re-tighten
Turn the TV on
If the lamp unit is not installed securely (e.g. flat
in the lamp housing area), the TV won't turn on.
In this case, reinstall the lamp unit.
Reset the lamp timer
6
1
Display the menu bar
2
Select "Set Up"
3
Select "Lamp Timer Reset"
Se t Up
Auto Program
Edit/Manual
Language
Decorder(EXT-2)
Component Auto Select
EXT Setting
HDMI Setting
PC Position
Lamp Timer Reset
4
Finish
Finally, the lamp has been replaced!
7
Never dispose of the lamp with normal trash!
The lamp contains a small amount of mercury. The lamp contains a small amount of mercury. Follow the instruction in
"Information for Users on Disposal of Old Equipment" (P.ii to iii).
If the power lamp and LAMP indicator blink rapidly after turning on the TV
"Lamp" (P. 21)
1 select
Set Up
2 next
1 select
Off
On
2 next
Press OK to reset
the lamp timer.
The lamp timer is
reset successfully.
5