ZyXEL Communications Super G Wireless HomePlug AV Router NBG318S Series Quick Start Manual page 12

If you cannot connect wirelessly to the NBG318S, check you have selected
the correct SSID and entered the correct security Key. If that does not
work, ensure your network adapter is enabled by clicking on the wireless
adapter icon and clicking Enable. See the User's Guide for more
suggestions.
5 Set Up a HomePlug AV Network with ENCRYPT
Use the ENCRYPT button to set up a secure connection between your NBG318S and
another HomePlug AV product with an ENCRYPT button (The PLA-400 v2 is shown below as
an example). Connect each powerline device one at a time.
1 Place the products close to each other, so you have time to set up each one. After you
press ENCRYPT on the first device, you have 120 seconds to press ENCRYPT on the
second one.
• You can disconnect them from the computer or modem (or other networking product) if you
need to, but the devices need to be plugged into power outlets.
2 Press the ENCRYPT button at the rear of both of your devices for more than 10
seconds. This sets up a random network name.
3 Press the ENCRYPT button at the rear of your device for 1~2 seconds.
4 Repeat step 3
done within 120 seconds of pressing the ENCRYPT button on the first device.
5 Wait for roughly one minute while your devices connect. The HomePlug (
both devices light up when the connection is successful.
1...2
in this section for the other device you wish to connect. This must be
ENGLISH
12
1...2
) lights on