Advertisement
Flight Modes
A3-L Supports 3 flight modes, you can switch between them using a 3-way switch on the transmitter. But if you are
using a 2-way switch instead then you can only use 2 of them during flight. The color of the LED shows you that the
flight mode currently selected, as shown below.
Flight Mode
1
Normal Mode
2
Gyro Off Mode
3
3D Flight Mode
Gyro Directions
It's extremely important to verify that the gyros of all
channels are reacting in the correct direction before flight,
otherwise it could lead to losing control or even crash
during a flight!
To perform the examination, power on the
plane, pick it up and check by following the steps in the
figures on the right. If the gyro compensates in an incorrect
direction, reverse it at once!
Aileron
Quickly move the right wing downward
around the roll axis. The right aileron surface should flap
down and the left flap up.
Elevator
Quickly move the nose of the plane downward
around the pitch axis. The elevator surface should flap up.
Rudder
Quickly move the nose of the plane to the left
around the yaw axis. The rudder surface should flap right.
Setting Methods
Setting Menu
Press and hold down the button for more than 2 seconds (long press), release it when the LED starts to blink Blue&Red
rapidly. In the setting menu, the LED should be blinking Blue&Red for N times in a loop with the sequence by the chart
below. N stands for the number of the setting function.
Functions
When you reach the function that you wish to operate in, quickly press the button once (short press) to enter it.
Parameters
After entering a function, the color of the LED shows you the settings currently selected. Each short press of the button
advances the option to the next value. When you finish making your selections, just wait for 5 seconds then system will
save the modified and back to the setting menu automatically. The colors corresponding to the options for each item
are as shown in the chart below. (* is the default setting).
Exit Setting Mode
When back to the menu, long press the button again to exit the setting mode.
http://www.hobbyeagle.com
Switch Position
Colors of LED
POS-1
Blue
POS-2 (Middle)
OFF
POS-3
Red
3 / 5
A3-L 3-axis Gyro User Manual
Descriptions
Normal Stabilization Mode
Gyro deactivated mode
AVCS Mode designed for 3D flight
support@hobbyeagle.com
V1.0
Advertisement
