Advertisement
Connection
Standard Receiver
the pins AIL, ELE, RUD, MOD and GAIN using the included receiver wires. The aileron, elevator and rudder should be
always connected or it could not work. The MOD is used for flight mode control, if you don't connect it the flight mode
will be set to normal as the default. The GAIN is used to adjust the master gain remotely. If you don't connect it the
gain will be set to 100% all the time as the default. Wiring is as shown in the figure below.
Futaba S.Bus
The Futaba's S.Bus and S.Bus2
is also supported by A3-L. Because the S.Bus is a
single-line solution all channels are transmitted
via one single line you need to establish the first 6
channels in the correct order in your transmitter
before use. Here we use a R7008SB receiver as an
example because it supports both S.Bus and S.Bus
2. You need to change the mode for the R7008SB
before using its S.Bus outputs, please refer to the
manual of it.
Delta-wing & V-tail
Never use the delta-wing and V-tail mixing
functions of your transmitter, all you need is to
choose a single 4-channel fixed-wing model in
your radio any time.
The right figure shows the
servo connections for a delta-wing or V-tail.
http://www.hobbyeagle.com
If a standard receiver is being used, you just need to connect the corresponding channels to
A3-L 3-axis Gyro User Manual
2 / 5
V1.0
support@hobbyeagle.com
Advertisement
