Adjustment Instruction - LG 27MK60TM Service Manual

1. Application
1.1 This document is applied to LM8EA chassis 22/24/27MK600M LCD Monitor which is manufactured in Monitor Factory
or is produced on the basis of this data.
1.2 Manufacturing Type: SET
2. Designation
2.1 The adjustment is according to the order which is designated and which must be followed, according to the plan which
can be changed only on agreeing.
2.2. Power Adjustment: Free Voltage
2.3. Magnetic Field Condition: Nil.
2.4. Input signal Unit: Product Specification Standard
2.5. Reserve after operation: Above 5 Minutes (Heat Run)
Temperature : at 25℃±5°C / Relative humidity: 65 ±10% / Input voltage: 100 ~ 240V, 50/60Hz
2.6. Adjustment equipments: Color Analyzer (CA-210 or CA-110, UA-10), DDC Adjustment Jig equipment,
3. Main PCB check process
After Manual-Insult, executing APC
* APC -
3.1 ADC Process
XxMK600M model use internal ADC, no need connect D-SUB cable
Internal ADC steps as below
On AC power on with Aging mode, checking the ADC values and then decide to do or
•
Read ADC OFFSET and GAIN flags from
•
If those values are not 0xAA on Aging mode, must do internal ADC calibration.
•
If the result of internal ADC calibration is OK, save the ADC result and make the OFFSET and
GAIN flags to 0xAA and make the Internal_ADC flag to INTERNAL.
•
Display the result of ADC on Aging Mode OSD and Service OSD
If don't use internal ADC, please follow below step
Input 16 step pattern for ADC (Mode12, pattern 11). (Video level : 700 mVp-p)
Adjust by commanding AUTO_COLOR_ADJUST
Confirm "Success" message in Screen or Check the data of
EEPROM(0XA6) is 0xAA after waiting 5 seconds
If there is "FAULT" message or the data of 0XFD, 0XFE address of EEPROM(0xA6) is not 0xAA,
do adjust again
If all Adjustment is completed, the values of 6500K, User Color and 9300K are saved automatically.
3.2 Main PCB Function test

ADJUSTMENT INSTRUCTION

- 9 -
0xA8 0x0D, 0x0E on NVRAM
Copyright © 2018 LG Electronics Inc. All rights reserved.
not,
0XFD, 0XFE address of
Only training and service purposes