Installing The Water Sampler - Global Water WS700R Manual

IV. Installing the Water Sampler
Refrigerator
a. The refrigerator is designed for freestanding installation only. It should not be
recessed or built in. Install the refrigerator on a base strong enough to
support it when fully loaded. Allow air to circulate freely around the
refrigerator. Provide a 1" clearance around the unit for proper circulation.
b. In the event of an electrical short circuit, grounding reduces the risk of electric
shock by providing an escape wire for the electric current. This appliance is
equipped with a cord having a grounding wire with a grounding plug. Do not
cut or remove the third (ground) prong from the power cord. Plug the
refrigerator cord into a wall outlet to start the cooling cycle. Set the
temperature knob to 4.
c. Never put food or beverages into the refrigerated wastewater sampler, it may
become contaminated.
Sampler
a. The control panel should be placed upright.
b. To secure the sample bottle:
c. Fasten the pump control panel enclosure down to the refrigerator by peeling
off the back from the adhesive fasteners. Press the control panel enclosure
firmly down so that it is not easily knocked loose.
d. Connect the depositing end of the pump hose to fitting at the top of the
refrigerator.
e. Plug the float switch lead between the bottle switch jack on the front of the
control panel and the jack at the top of the refrigerator.
f. Plug the AC power supply plug into the jack on the front of the control panel
and plug the power supply into the wall outlet. Unplug the power supply when
not in use.
g. The unit is water resistant, not water proof. The unit must be located well
above the water level to continue to provide reliable service.
Global Water
800-876-1172 • globalw.com
1) Screw the bottle caps/float switch onto the sample bottle
2) Place bottle into the refrigerator
3) Plug the float switch into the jack located on the inside at t he
top left
4) Insert the sampler hose into the hole in the lid
- 5 -