Advertisement
Settings
3 -
The built-in mixing console on the Natural5, Natural6 and Personal6 amps offers a whole range
of inputs, settings and other options:
DSP Multi-effects Processor (only on Natural6)
(1) A button to select one of the eight pre-set DSP effects. The relevant effect is
indicated by a green LED.
(2) The REV RET knob in the MASTER control section controls the output level for a
DSP effect.
A DSP reverb (only on Natural5)
(1) A button to select one of the eight pre-set DSP effects. The relevant effect is
indicated by a green LED.
(2) The REV RET knob in the MASTER control section controls the output level for a
DSP effect.
Anti-Feedback (only on Natural5/6)
(3) An ON/OFF button activates/deactivates the anti-feedback effect.
(4) The ANTIFEEDBACK knob controls the effect (100 to 250Hz).
With this effect you can suppress the feedback created by an electro acoustic guitar
when played at high volume near the amp. The attenuation filter offers 12dB sound
reduction over an adjustable frequency range of 100 to 250Hz.
Phantom Power (only on Natural5/6)
(5) An ON/OFF button activates/deactivates the PHANTOM POWER (+48V) supply that
features balanced XLR inputs for the first two audio inputs.
This power source is essential for most types of condenser mic.
Ground Lift
(6) By using this switch you can break the connection to the electrical earth.
Eliminates unwanted hum and buzz by preventing current flow between devices.
Main Switch
(7) Natural6 ON/OFF switch.
As a safety precaution, never use the amp at maximum power when it has just been
switched on from 'cold'. Wait for the components to warm up (2 to 10 minutes
depending on room temperature).
Illustrations et photos non contractuelles
Actual product(s) may differ from illustrations/photographs used
Copyright © 2016 IPE Music/Prodipe
Page 5
Advertisement
