iBasso P5 Falcon Owner's Manual

iBasso Headphone Amplifier P5 Falcon
Main Features:
- Three Channel or Four Channel compatible
architecture design.
- A total of 8 gold-plated DIP sockets for OPAMPs
and Buffers allowing for opamp or buffer rolling.
- 3 Gain settings for impedance matching.
- Bass boost to enhance bass performance.
- Powered by dual 9V batteries, or the P5 power
supply.
- High output power, 660mW+660mW into 32Ω when
powered by batteries, or 1000mW+1000mW into
32Ohm when powered by the P5 power supply.
- CNC engraved aluminum housing, which can be
opened with just one screw.
Caution:
To protect your hearing, please follow the operation
guide and do not listen at extremely high volume
levels. Extended high volume listening can lead to
permanent hearing loss.
Contents:
iBasso P5, rubber feet, connection cable, and
warranty card. Also comes with an OPAMP rolling
kit that includes the following OPAMPs and Buffers.
OPAMP/BUF Qtt.
OPA627 2
NE5534 biased 2
BUF634U 4
BUF634P WB 4
Transistor BUF 4
Dummy
4
adapter
OPA627*2, BUF634U*4,
mounted on the P5.
Inserting and Charging the Battery:
Before inserting the 9V batteries, check the position
L/R BUF Singe
VG/OG
• • •
－
• • •
－
• • •
－
－ • • •
• • •
－
• • •
－
and BUF634P*4
of positive and negative terminals. Make sure the
batteries are being placed in correct direction.
The P5 power supply can charge
only. When using 9V Li-ion or other 9V non NiMH
batteries in the P5, the power supply must be
disconnected to avoid harm to the batteries or the
power supply.
could cause fire and or the batteries to explode.
There is not charge lamp on the P5 or the P5 power
supply. The batteries are being charge once the P5
power supply is connected.
fully charged after
current is small and limited, you can leave the P5
power supply
concerns.
OPAMP and Buffer Rolling
Before opening the housing to change OPAMPs or
buffers, make sure the P5 is turned off. OPAMPs
and Buffers can be damaged by static electricity. It is
better to change OPAMPs and buffers in a static-free
environment. Also, before inserting the OPAMPs in
the sockets, check to make sure if it is a single or dual
OPAMP, then place it to the right position.
Dual
－
－
－
－
－
－
are
Direction of Inserting the OPAMP and Buffer:
In the following drawing, the first pin of the OPAMPs,
1
Owner's manual
9V NiMH batteries
Failing to follow these directions
The batteries will be
8~16 hours. Since the charge
plugged with no over-charging