Paper Jams; Overheat Protection; Overload Protection - Quer URZ0951 Owner's Manual

2. Make sure the shredder head is mounted properly.
3. Set the Mode switch to AUTO position.
4. Insert a CD, DVD or a credit card into the center of the CD/DVD/credit card
entry slot.
• Insert credit cards lengthwise into the entry slot.
5. Shredding starts automatically.
IMPORTANT! Only one CD, DVD or credit card can be shred at a time.
6. CDs and DVDs are shredded into three pieces which are collected in a
dedicated tray inside the wastebasket.
• Make sure to empty the tray regularly!

PAPER JAMS

If the following situations occur, the cutting head may jam:
1. Too much paper was inserted into the paper entry slot in single pass.
2. Paper was inserted incorrectly into the paper entry slot.
3. Inserted paper was not stacked neatly.
4. Paper was crumpled.
5. The wastebasket is overfilled with cutting waste.
To clear the jam, set the Mode switch to REV position. Cutting head runs in
reverse ejecting the paper out.

OVERHEAT PROTECTION

If continuous operation of the device exceeds 2 minutes, motor may overheat
and the device will automatically turn off. Please wait around 30 minutes until
motor temperature drops to the safe level. Then turn on the device by setting the
Mode switch to AUTO position.

OVERLOAD PROTECTION

If too many sheets of paper are inserted into the paper entry slot, the shredder
will not start shredding. Set the Mode switch to REV position to take the paper
out of the entry slot. Reduce the number of sheets, set the Mode switch to AUTO
position and try again.
EN
Owner's manual
13