Advertisement
REF
QTY
PART DESCRIPTION
7
1
Main Strap
8
2
ITW Nexus Triglide Adjustment Buckle
9
1
Female Buckle Assembly
1
Instructions
TOOLS REQUIRED
No tools required.
IMPORTANT
Your ADJUSTABLE GAS CAN HOLDER KIT is exclusively designed for your vehicle. Please read the
installation instructions thoroughly before beginning. Installation is easier if the vehicle is clean and free of
debris. For your safety, and to ensure a satisfactory installation, perform all installation steps correctly in the
sequence shown.
ASSEMBLY TIME
Approximately 20 minutes
INSTALLATION INSTRUCTIONS
IMPORTANT
The maximum capacity of the tunnel of the
snowmobile is 6.8 Kg (15 lbs).
1. Insert four carriage bolts
of the snowmobile, two on each side.
2. Insert the main plates
the bolts in the adjustment slots.
3. Insert the side plates
4. Install the four washers
do not tighten them firmly.
q
in the tunnel grooves
t
into the tunnel, aligning
y
t
in the main plates
w
and the four handles
Instr 9924828
Rev 02 2016-08
5. Install the male buckle
the strap on the front and rear using the female
buckle assembly
t
plates
.
.
e
,
6. Place the can between the plates. Center it on the
tunnel and tighten the plates using the handles
Page 2 of 3
PART NUMBER
-
-
-
9924828
r
u
on the strap
o
into the slots of the main
. Install
e
.
Advertisement
