Advertisement
IMPORTANT SAFETY INSTRUCTIONS
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION
CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT
AND THE HAZARDS INVOLVED.
CE PRODUIT DOIT ÊTRE INSTALLÉ SELON LE CODE D'INSTALLATION PERTINENT, PAR UNE
PERSONNE QUI CONNAÎT BIEN LE PRODUIT ET SON FONCTIONNEMENT AINSI QUE LES
RISQUES INHÉRENTS.
1. READ AND FOLLOW ALL SAFETY
INSTRUCTIONS.
2. INSTALLATION REQUIRES KNOWLEDGE
OF LED LIGHTING AND ELECTRICAL
SYSTEMS.
3. THE LED LUMINAIRE MUST BE WIRED IN
ACCORDANCE WITH THE NATIONAL
ELECTRICAL CODE AND APPLICABLE
LOCAL CODES.
4. PROPER GROUNDING IS REQUIRED FOR
SAFETY.
5. THIS LED LUMINAIRE MUST BE
INSTALLED PER THE APPLICABLE
INSTALLATION CODE BY A PERSON
FAMILIAR WITH THE CONSTRUCTION
AND OPERATION OF THE PRODUCT. DO
NOT ATTEMPT INSTALLATION IF THIS
CONDITION IS NOT MET. CONTACT A
QUALIFIED ELECTRICIAN.
VIENTO WALLPACK
6. DO NOT USE THIS LUMINAIRE FOR
ANYTHING OTHER THAN ITS INTENDED
USE.
7. DANGER-RISK OF
FIRE OR
ELECTRICAL
SHOCK-
DISCONNECT
POWER BEFORE
BEGINNING
INSTALLATION.
Advertisement
Table of Contents
Summary of Contents for XtraLight VIENTO WALLPACK
- Page 1 VIENTO WALLPACK IMPORTANT SAFETY INSTRUCTIONS THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED. CE PRODUIT DOIT ÊTRE INSTALLÉ SELON LE CODE D’INSTALLATION PERTINENT, PAR UNE PERSONNE QUI CONNAÎT BIEN LE PRODUIT ET SON FONCTIONNEMENT AINSI QUE LES...
- Page 2 VIENTO WALLPACK INSTALLATION THIS LUMINAIRE IS INTENDED FOR SURFACE MOUNT ONLY. 1. Remove (4) Housing Screws and depress Spring Clip to open fixture. Lift fixture housing off of the Hinges, and set aside. (Figure 1) 2. Make necessary holes in back plate gasket included with fixture. Peel adhesive and adhere gasket to back of Back Plate.
- Page 3 VIENTO WALLPACK 4. Connect supply wires to quick disconnect provided. Follow wiring directions in “Wiring” section on next page. 5. Swing fixture up and closed until Spring Clip snaps into place. 6. Replace (4) Housing Screws. 7. Turn power on.
- Page 4 VIENTO WALLPACK WIRING Universal driver: 120VAC - 277VAC, 50/60HZ. 1. Verify that the electrical power to the Luminaire is in the OFF position. 2. Connect the fixture side Black lead to Line supply lead 3. Connect the fixture side White lead to Neutral supply lead.
Need help?
Do you have a question about the VIENTO WALLPACK and is the answer not in the manual?
Questions and answers