Table of Contents
Advertisement
LED
COLOR
PWR/SYS
Green
ETHN
Green
Amber
WLAN
Green
To access the ZyAIR, configure your computer's IP address and subnet mask to be in the same range as the
ZyAIR's.
3 Set Up Your Computer's IP Address
Skip this section if your computer's IP address is already in the range of
192.168.1.3 ~ 192.168.1.254 with subnet mask 255.255.255.0.
Your computer must have a network card and TCP/IP installed. TCP/IP should already be installed on
computers using Windows NT/2000/XP, Macintosh OS 7 and later operating systems. Refer to the Setting
Up Your Computer's IP Address appendix in the User's Guide for other operating systems.
3.1 Windows 2000/NT/XP
1.
In Windows XP, click start, Control Panel. In Windows 2000/NT, click Start, Settings, Control
Panel.
2.
In Windows XP, click Network Connections.
In Windows 2000/NT, click Network and Dial-up Connections.
ZyAIR G-500 802.11g Wireless Access Point
Table 1 ZyAIR Front Panel LED Description
STATUS
Blinking
The ZyAIR is not ready or rebooting.
On
The ZyAIR has a successful reboot and is receiving power.
Off
The ZyAIR is not receiving power.
Off
The ZyAIR does not have an Ethernet connection.
On
The ZyAIR has a successful 10Mbps Ethernet connection.
Blinking
The ZyAIR is sending/receiving data.
On
The ZyAIR has a successful 100Mbps Ethernet connection.
Blinking
The ZyAIR is sending/receiving data.
Blinking
The ZyAIR is sending or receiving data through the wireless LAN.
On
The ZyAIR is ready, but is not sending/receiving data.
The default IP address of the ZyAIR is 192.168.1.2.
DESCRIPTION
6
Advertisement
Table of Contents
