Casio SF-4300R Service Manual & Parts List page 9

Setting up for Data Communications
The following procedures describe what you should do to set up for data communications between
two SF Units or between an SF Unit and a personal computer. In addition to hardware connections,
it details how to set up the communications parameters and how to set up the SF-4300R to receive
data. By following these instructions carefully, you can be ensured of successful communications
every time.
To connect two SF Units
1. Check to make sure that the power of the two SF Units is switched off.
2. Remove the covers from the connectors on the two SF Units.
3. Connect the two SF Units using the optional SB-60/62 cable. You can also connect them using
an SB-60/62 cable.
Important
Be sure to replace the connector covers on the SF Units when you are not performing data
communications.
4) Check the hardware parameters.
Select "TEL" mode or press 1 under MENU screen.
1.
2. Press FUNC twice to display the second function menu.
FUNC FUNC
• You can perform the above operation while the initial screen of the Memo Mode, Schedule
Keeper, Calendar, or Reminder is displayed also.
3. Press 4 to select DATA COMM.
4
4. Press 3 to select SET UP.
3
1* TO SECRET AREA
2 ALL DELETE
3 LABEL EDIT
4 DATA COMM
CAPS
1 SEND
2 RECEIVE
3 SET UP PAR.
CAPS
SET UP PAR.
PARITY E O N
BIT LENGTH 7 8
BPS 4800 9600
CAPS
— 7 —
* If the password isn't
registered in the SF unit,
display shows X instead
of "1".
• N is blinking.