13 Appendix A – RS-232 Commands and
Communication
Set serial communication settings to:
•
Baud Rate:
•
Data bits:
Stop bits:
•
RS-232 commands can use upper or lower case characters.
•
For firmware version 01.04.00 all commands described here are valid.
•
•
For firmware version 01.01.00, all commands described here are valid.
•
For firmware version 01.00.00, all commands except '^' and "v" are
valid.
Command
Response
nnn[cr]
None if Ok.
"Bad" is
returned if the
number is
invalid.
^
None
v
None
38000-L01-001_Rev_J_SugarCUBE_Manual
19200
8
Parity:
1
Flow Control:
Description
Adjusts intensity to the number entered.
To change the LED intensity, enter 'nnn' where
'nnn' is an LED intensity from 10 – 100 with a
trailing carriage return; leading 0 is optional
Increases intensity to next 10% level.
This will have the same effect as pressing the
Increase Intensity button on the front panel (if
the unit is in the unlocked state).
This command is not functional with firmware
v01.00.00
Decreases intensity to next 10% level.
This will have the same effect as pressing the
Decrease Intensity button on the front panel
(if the unit is in the unlocked state).
This command is not functional with firmware
v01.00.00
None
None
26