ZyXEL Communications ZyXEL Prestige 304 Quick Start Manual page 5

Prestige 304 Broadband Sharing Gateway with 4-Port Switch
Turning on Your Prestige
Plug the male end of the power adapter into a power outlet. The SYS LED turns
on. The WAN and the LAN LED(s) turn on after the system tests are complete,
if the WAN and LAN ports are properly connected.
RESET Button
If you forget your password or cannot access the Prestige, use the RESET
button on the rear panel of the Prestige to reinstall the configuration (rom) file.
Uploading the configuration file replaces the current configuration file with the
default configuration file and deletes all customer-made Prestige configurations.
The following are Prestige factory defaults:
IP address: 192.168.1.1
Password: 1234
Using the RESET Button
1. Use a pointed object to press the RESET button for five seconds, then
release it.
2. If the LAN LEDs flash within 30 seconds, the factory defaults have been
restored and the Prestige restarts. Otherwise, go to step 3.
3. Turn the Prestige off.
4. While pressing the RESET button, turn the Prestige on.
5. Continue to hold the RESET button for about 30 seconds. The Prestige
restarts.
6. Release the RESET button and wait about ten seconds for the Prestige to
finish restarting.
5