Advertisement
Figure 4
C. Refer to Figure 4 (Green). Plug one end of the tubing into fitting #2. Press the tubing into the channel,
around the loop near the wrist, and back to the connector block at fitting #3.
Figure 5
D. Refer to Figure 5 (Yellow). Plug one end of the tubing into fitting #7. Work it into the channel down
the forearm, around the palm side of the thumb, and back toward the connector block in the same
channel. Pass the tubing over the first section of "green" tubing and under the second section (refer
to diagram above). Connect the tubing to fitting #5.
Figure 6
E. Refer to Figure 6 (Blue). Plug one end of the tubing into fitting #6. Tuck it under the "green" tubing,
then continue to press it into the channel, taking extra care to minimize pinching in the loops around the
two fingers and the back of the hand. Run the tubing under the "red" tubing and over both lengths of
"yellow" tubing before connecting to fitting #8.
F. Double check that all the tubing is in the correct channel and free of kinks or other obstructions. Check
that all fitting connections are as tight as possible to prevent leaks.
4
Advertisement
