Current Mp113 Operation Mode; Power On Options; Module I2C Address - Apex Digital MP113 Manual

Table of Contents

MP113

CURRENT MP113 OPERATION MODE

The "Current MP113 Operating Mode" shows the mode of the MP113. This field can only be changed if

MP113 is offline. Valid operation modes are:

•

Binary Mode

•

Single Color Mode

•

Dual Color Mode (only available for the 2-color version of MP113)

Please refer to the MP113 Data Sheet for the details on the operating modes. If you want to change the

operation mode select the new mode from the pull-down menu and click OK.

Changing the "Current MP113 Operation Mode" will not change the startup mode of the

MP113. If you want to permanently change the mode of MP113, you need to change the

"Power On Option" at the same time.

The "Power on Options" allow you to select the behavior of MP113 at power-up. Besides selecting the

operation mode, you can also define if the MP113 is set to demo/evaluation mode.

The status of MP113 (online/offline) can be controlled through the serial communication interface at any

point in time. If you need some time to set up the other components of your system before MP113 can

receive printing information, you should keep MP113 offline after startup. Once your initialization of the sys-

tem is complete, you issue MP113 the command to go online through the serial communication interface.

The MP113 Configuration Dialog also allows you to set the I2C address of the module. Please select the

proper value in the related input box. By default, MP113 has the I2C address of 0x50 (hex). A change in the

I2C address become active immediately after clicking the OK button.

Figure 11: MP113 Configuration Dialog

MP113GMU Rev B

Table of Contents