Hazards When Using And Handling The Power Tool; Service / Maintenance / Repair - Baier BDB 822AP Translation Of The Original Instruction Manual

EN
2.7.5 Hazards when using and
handling the power tool
•
If the machine is used for hand-held
drilling, always hold both handles firmly
when switching on and while working with
the machine. (The additional handle must
be tightly screwed onto the drill!). When
switching on and while working with the
machine, expect reaction torques (e.g. due
to sudden jamming or breakage of the insert
tool).
•
Do not use any accessories, which have not
been especially provided and recommended
for this power tool by the manufacturer.
Just because you can attach the accessories
to your power tool is not a guarantee of safe use.
•
The approved speed of the insert tool must
be at least as high as the maximum speed
given on the power tool.
Accessories which rotate faster than approved
can break and fly off the tool.
•
Change insert tools carefully and only use
the mounting tools provided, if they are in
perfect condition. Disconnect the mains
plug before changing the insert tool.
Use of the mounting tool provided prevents
damage to the power tool and insert tool.
•
Never use damaged insert tools. Before
each use, check insert tools for splinters
and cracks. If the power tool or insert tool
is dropped or falls, check whether it is
damaged, or use an undamaged insert tool.
If you have checked and inserted the insert
tool, keep yourself and other people nearby
outside the plane of the rotating insert tool
and let the power tool run at maximum speed
for one minute.
Most damaged insert tools break during this test
period.
•
Do not expose power tools to extreme heat
or cold.
Mechanical and electrical damage can occur
during extreme heat and/or cold.
•
Allow the insert tools, tool holders and other
parts cool in the immediate vicinity of the
work area after use.
The equipment can be very hot after use. Do not
touch or grip the parts. Risk of injury.
| 28 |
•
Additional signs or other, non BAIER-
specific parts may not be screwed or
riveted onto the motor, handle, gearbox or
protective housing.
This could damage the power tool and cause
malfunctions to occur.
•
Avoid unnecessary noise emissions.
•
Note and follow the safety and work
instructions for the accessories used.

2.7.6 Service / Maintenance / Repair

•
If the power tool is dropped or becomes wet,
have it checked.
A possibly damaged power tool is dangerous
and no longer safe to operate. Before using
the power tool again, have it checked by our
customer service or an authorised service
centre of Maschinenfabrik OTTO BAIER GmbH.
•
Repair and maintenance work may only be
carried out by an authorised workshop of
Maschinenfabrik OTTO BAIER GmbH.
Otherwise, all liability and warranty claims
against Maschinenfabrik OTTO BAIER GmbH
expire.
•
Ensure that original BAIER spare parts and
original BAIER accessories only are used
when needed.
Original parts are available from authorised
dealers. Use of non original parts can cause
damage to the machine and an increased risk of
accidents.
•
Regular servicing by Maschinenfabrik OTTO
BAIER GmbH or a servicing and repair
company authorised by us is specified.
Many accidents are caused by poorly serviced
and maintained power tools.