Advertisement
Available languages
Available languages
20. AUDIO INPUT: line in 100mV-1Vpp audio single.
21. OUT PUT: VDE socket.
22. FUSE: T6.3A 250V 5X20MM
3 - Operating instructions
1. Confirm the loading and power are connected. Then turn on the power switch.
2. Press Mode select to select desired mode from Hold dimmer/Hold sound/prog sound/prog speed /Memory.
HOLD DIMMER: channel output is controlled by channel dimmer control and master control.
Corresponding indicator is lighting.
HOLD SOUND: corresponding indicator is lighting. Channel output is controlled by channel control
and the music sensitivity is adjusted by the AUDIO LEVEL control.
PROG SOUND: you can select desired program from 42 pre-set using Prog.Select button. Press button
once, program will be increased. Press Prog select and hold it one second, program will be increased 10steps
pre second. Press Prog select + Mode select then program will be decreased. Corresponding indicator is
Chasing speed is controlled lighting by audio single.
PROG SPEED: corresponding indicator is indicator is lighting .the way is same as PROG SOUND but
the chasing speed is controlled by speed control to Tap sync.
AUTO SPEED: operation according to Prog speed. In these modes each program will be executed four
times. Then go to next program corresponding indicator is lighting.
AUTO SOUND: operation is same as Auto speed. Each program will be executed four times.
MEMORY: in this mode, you can select desire operation mode from program/manual/Auto speed.
Corresponding to digit indicate "PR, ST, AS, AP". Press and hold prog select, then press stand by once. PROG
DISPLAY will show present operation mode. Press stand by once more, next mode will be selected.
PR mode: press prog select till "0 1"appear in DISPLAY, adjust Master dimmer control or channel
dimmer control to meet user's requirement .press prog select button, the DISPLAY will flash 4 times
continuously, which means it is memorized and DISPLAY Will show "0 2".You can make program in this way
till "32" appears. Now exit from "PR" mode and engage in other mode, if you fail in certain step, you should
restart programming, otherwise not effective.
ST mode: in this mode, press prog select once, program will execute one step the DISPLAY will show
the information.
AS mode: program is executed according to the music rhythms and display shows the steps.
9
Advertisement
