Rowenta ACTISTEAM Manual page 13

Anti-Drip system
The Anti-Drip sytem prevents water escaping from the soleplate
when the temperature is too low.
Anti-Calc system
The integrated anti-calc system gives better quality ironing: a
constant flow of steam throughout the ironing session and longer
lasting performance of your appliance.
PROBLEMS?
Problems
The iron is
plugged in, but the
soleplate of the
iron remains cold.
Thermostat
control light goes
on and off.
None or too little
steam is being
emitted.
Brown streaks
come through the
holes inthe
soleplate and
stain the linen.
Iron is leaking.
If you have any further problems or queries please contact our Custo-
mer Relations Team first for expert help and advice:
Helpline: 0845 602 1454 - UK / (01) 4610390 - Ireland
Or consult our web site: www.rowenta.co.uk
(depending on model)
(depending on model)
Cause
No mains supply.
Temperature control set
too low.
The automatic electronic
cut-out* is active.
This is normal.
Steam control set on dry
position .
Not enough water in the
water tank.
Residues in the steam
chamber or on the
soleplate.
Use of chemical
descaling agents.
Fabric fibres have
accumulated in the holes
of the soleplate and are
burning.
Your linen is not rinsed
sufficiently or you have
ironed a new garment
before washing it.
Use of starch.
Pure distilled /
demineralised or
softened water is
being used.
Overuse of shot of steam
button.
Soleplate temperature
too low.
Solution
Check that the mains plug is
properly inserted or try plugging
the iron into a different socket.
Set the temperature control to a
higher temperature.
Move your iron.
When the thermostat control light
goes on and off the iron is heating
up. As soon as the thermostat
control light goes off the set
temperature has been reached.
Turn the steam control to the
required setting area.
Fill the water tank.
Use the Self Clean function then
clean your iron.
Do not add any descaling agents to
the water in the water tank. Use the
Self Clean function and clean your
iron.
Clean the soleplate with a
non-metallic sponge.
Vacuum the holes of the soleplate
from time to time.
Ensure linen is rinsed thoroughly
to remove any soap deposits or
chemicals on new garments which
may be sucked by the iron.
Always spray starch onto the
reverse side of the fabric to be
ironed and clean your iron
soleplate.
Only use untreated tap water or
mix half tap water with half
distilled/demineralised water. Use
the Self Clean function and clean
your iron.
Allow more time between each
shot.
Set the temperature control to a
higher temperature.
Subject to modifications !
13
GB
F
NL
D
DK
S
N
FIN
PL
CZ
SK
SLO
SR
HR
RO
H
EST
LT
LV
TR
BG
AR