AEG L6TB61379 User Manual page 14

14 www.aeg.com
Set this option to change the default
temperature.
The indicator
temperature comes on (the appliance
does not heat the water).
7.4 U/min.
When you set a programme, the
appliance automatically sets the
maximum spin speed allowed.
Touch repeatedly this button to:
• Decrease the spin speed.
The display shows only
the spin speeds available
for the set programme.
• Activate the Rinse Hold option.
The final spin is not performed. The
water of the last rinse is not drained
out to prevent the fabrics from
creasing. The washing programme
ends with water in the drum.
The display shows the indicator
The lid stays locked and the drum
turns regularly to reduce creasing.
You must drain the water to unlock
the lid.
If you touch the Start/Pause button,
the appliance performs the spinning
phase and drains the water.
The appliance empties
the water out
automatically after 18
hours approximately.
• Activate the Extra Silent option.
The intermediate and the final
spinning phases are suppressed and
the programme ends with water in the
drum. This helps to reduce creasing.
The display shows the indicator
The lid stays locked. The drum turns
regularly to reduce creasing. You
must drain the water to unlock the lid.
As the programme is very quiet, it is
suitable for use at night time when
cheaper electricity tariffs are available.
In some programmes the rinses are
performed with more water.
If you touch the Start/Pause button,
the appliance performs the only
draining phase.
= cold water of the set
The appliance empties
the water out
automatically after 18
hours approximately.
7.5 Flecken/Vorwäsche
Press this button repeatedly to activate
one of the two options.
• Flecken
Select this option to add an anti-stain
phase to a programme in order to
treat heavily soiled or stained laundry
with stain remover.
Pour the stain remover into
compartment
will be added in the appropriate
phase of the washing programme.
This option can increase
the programme duration
and is not available with a
temperature lower than
40 °C.
.
• Vorwäsche
Use this option to add a prewash
phase at 30 °C before the washing
phase.
This option is recommended for
heavily soiled laundry, especially if
containing sand, dust , mud and other
solid particles.
This option can increase
the programme duration.
The corresponding indicator above
the touch button illuminates.
7.6 Spülen
With this button you can select one of
. the following options:
• Option Extra Spülen
This option adds a few rinses
according to the selected washing
programme.
Use this option for persons allergic to
detergent residues and in areas
where the water is soft.
This option increases
slightly the programme
duration.
• Skipping wash phase - Nur Spülen
. The stain remover