Advertisement
3. If the receiver is to be located remotely from the
control
4. Mounting the 5881EH in a Separate Cabinet For
Commercial Fire Applications.
mounted in a separate cabinet,
The cabinet containing the receiver must be located no
farther than 20 feet from the alarm control cabinet., with no
intervening walls or barriers):
5. Setting The DIP switches (All Receivers):
www.PDF-Zoo.com
5881EH Only:
DIP switch #5 is used on the 5881EH, as follows:
Note:
6. Insert the wiring plug (with 4 flying leads) into the
mating socket on the receiver
SPECIFICATIONS
7. Install the antennas
Important!
8. Replace the receiver's cover
9. Proceed with any programming of the control that may
be necessary for RF operation, and the installation of
the system's wire less transmitters,
10. The LED located on the receiver's circuit board
SPECIFICATIONS
Dimensions:
Input Voltage:
Current:
Interface Wiring:
Range:
TO THE INSTALLER
2
right-hand
Advertisement
