Advertisement
This Manual describes the mapping functionality of the GFX4-ETH1 EthernetIP Adapter to ModbusRTU Master via
acyclic CIP messages.
This functionality is realized in a separate Firmware/Hardware connected to the standard Gefran GFX4 controller.
For all general GFX4 functionalality refer to manuals availables for download at Gefran web site www.gefran.com
The following documentation overview gives information, for which items you can find further information in which
manual.
Manual
Vol7_1.0.pdf
The Firmware for the GFX4-ETH1 (EthernetIP-RTUMaster) does not need any configuration to operate.
All necessary settings are fix and predefined. After power up the GFX4-ETH1 sends DHCP requests to obtain an IP
address.
Therfore a running DHCP server is required. .
TCP/IP:
• DHCP disable
• Baud rates 10 and 100 MBit/s
• Data transport layer Ethernet II, IEEE 802.3
• default IP 192.168.1.100, NM 255.255.255.0, gw 0.0.0.0
• CH0 and CH1 con switch integrato
MODBUS RTU
• Baud rate = 19200
• Parity = NONE
• Stop Bits = 1
• Data Bits = 8
System Requirements
• EthernetIP Master / Scanner
• GFX4-ETH1 with EthernetIp board
• DHCP server (optional)
2
1 • Introduction
Referenced Documentations
Contents
Integration of Modbus Devices into
the CIP Architecture
2 • Configuration
Document name
THE CIP NETWORKS LIBRARY
Vol. 7 Edition 1.0
80409D_MSW_GFX4-ETH1_04-2013_ENG
Advertisement
