Adjusting Throttle Cable; Break-In Operation - RedMax Sweeper RMSZ2500 Owner's/Operator's Manual

8. Operation
OP5
.04 in
(1~2mm)
OP6
OP7
■ STOPPING ENGINE (OP3)
1. Release the throttle lever and run the engine for
2. Shift the ignition switch to the STOP position.
• Except for an emergency, avoid stopping the

■ ADJUSTING THROTTLE CABLE

• The normal play is 1 or 2mm when measured at
(1)
(1) Cable Adjuster
■ ADJUSTING IDLING SPEED (OP6)
1. When the engine tends stop frequently at idling
2. When the cutting head keeps rotating after
(1) Idle Adjusting Screw
(1)
• Warm up the engine before adjusting the idling

■ BREAK-IN OPERATION

The Properly Dressed Operator (OP7)
(1) ALWAYS wear hearing protective devices.
(2) ALWAYS wear eye protection such as goggles
(3) ALWAYS wear a mask to protect against dust
(4) ALWAYS wear close fitting clothes. Gloves
(5) ALWAYS wear leather or heavy-rubber shoes.
(6) BEWARE of thrown debris!
(7) DIRECTION OF ROTATION
a half minute.
IMPORTANT
engine while pulling the throttle lever.
the carburetor side end. Readjust with the cable
adjuster as required. (OP5)
mode, turn the adjusting screw clockwise.
releasing the trigger, turn the adjusting screw
counter-clockwise.
NOTE
speed.
or safety glasses.
or other airborne particles.
offer added protection and are strongly
recommended. Do not wear clothing or jewelry
that could get caught in machinery.
NEVER work barefooted!
19 