Setup; Installing The Handle; Adjusting The Handle Height - Toro TurfMaster 22205TE Operator's Manual

Setup

Important:
Remove and discard the protective
plastic sheet that covers the engine and any other
plastic or wrapping on the machine.
1

Installing the Handle

No Parts Required
Procedure
WARNING
Folding or unfolding the handle improperly
can damage the cables, causing an unsafe
operating condition.
• Do not damage the cables when folding or
unfolding the handle.
• If a cable is damaged, contact an
Authorized Service Dealer.
1. Remove the 2 bolts from the machine frame in
the location shown in
1. Bolt (2)
2. Rotate the handle rearward to the operating
position.
3. Secure the handle to the machine with the bolts
that you removed in step
4. Tighten the fasteners that support the handle on
both sides of the machine as shown in
Figure 3.
Figure 3
2. Nut on handle support
bracket (2)
1
Figure
1. Cable tie
2. Nut on handle support
bracket (2)
5. Use a cable tie to secure the cables to the lower
handle in the location shown in
6. Secure the cable tie on the handle and trim off
the excess material from the tie.
2
Adjusting the Handle
Height
No Parts Required
Procedure
1. Stand in the operating position to determine the
most comfortable handle height.
g028426
2. Remove the handle bolt and insert it in 1 of
the 3 holes located at the bottom of the handle
bracket (Figure
4.
5
Figure 4
3. Bolt (4)
Figure
5).
g028427
4.