Raco GUARD-IT Owner's Manual
  1. Manuals
  2. Brands
  3. Raco Manuals
  4. Telephone System
  5. Guard-It
  6. Owner's manual

Raco GUARD-IT Owner's Manual

Hide thumbs Also See for GUARD-IT:
1
2
3
4
5
6

Advertisement

Table of Contents

TM
Owner's Manual
TM
Guard-It
Owner's Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the GUARD-IT and is the answer not in the manual?

Questions and answers

Related Manuals for Raco GUARD-IT

Summary of Contents for Raco GUARD-IT

  • Page 1 Owner's Manual Guard-It Owner's Manual...
  • Page 2 Wiring Connections Guard-It Front Panel Diagram Channel Light Indications: Flashing red indicates loss of external 12 VDC power. After 5 minutes, alarm calls will be placed. Upon acknowledgement, Steady green - Normal light is on with no flashing until power is restored.
  • Page 3 Programming Your Guard-It Autodialer Programming Your Guard-It Autodialer Programming Menu To program your Guard-It autodialer, you will need a standard touch-tone telephone. Telephones which have the keypad located separately from the handset, are most convenient for this purpose. Just plug the telephone temporarily into the Programming Jack on the front panel of the product, lift the receiver, and follow the voice menu to enter your programming and record your voice messages.
  • Page 4 Programming Your Guard-It Autodialer Programming Flow Chart Guard-It 4 - 2 Guard-It Owner's Manual...
  • Page 5 Refer to Appendix A for additional information on programming for analog signal inputs. 4.1.2 Phone Number Programming You must program at least one phone number for your Guard-It autodialer PHONE to dial when it has an alarm to report. NUMBERS...
  • Page 6 You might temporarily program an alarm reset time of, say, four hours, so that you would get a new set of calls every four hours until the battery lost charge. Guard-It Owner's Manual...

Table of Contents