Table of Contents
Advertisement
Hook Up Antenna and VCR to the TV
Connect an off-air antenna and VCR to the TV
1
Locate the Antenna/Cable jack on the back of the VCR.
2
Connect the cable that runs from the antenna directly to
this jack, according to the diagram to the right. As
required, make the other connections as shown to the
right.
3
Remove the back of the remote, put in two AA batteries.
4
Plug in the TV. Do not plug it into a switched outlet. The
TV is designed to operate on standard current, 120-volt
60 Hertz AC. Do not attempt to operate it on DC Current.
120 V AC
60 Hz
5
Go to page 12 to Auto Program the TV.
No A/V cables are included with the Zenith TV.
Without A/V cables, most VCRs will not play videocas-
settes in stereo sound.
206-3489-O
back of
remote
Antenna
Flat wire
(300 ohm)
300/75 ohm
Adapter
TV back
ANTENNA
CABLE
VIDEO
MATRIX
IN
OUT
M.P.I.
R- AUDIO- L
IN
TV back panel
(expanded view)
A/V cables
not included
with TV
Antenna
RF coaxial wire
(75 ohm)
TV back
RF coaxial wire
(75 ohm)
not included
TV back
with TV
ANTENNA
CABLE
VIDEO
MATRIX
OUT
IN
M.P.I.
R- AUDIO- L
IN
TV back panel
(expanded view)
A/V cables
not included
with TV
VCR back
VCR back AV panel
output
In
switch
3 4
Out
Audio
Video
VCR back
VCR back AV panel
output
In
switch
3 4
Out
Audio
Video
P A G E 9
Advertisement
Table of Contents
