Advertisement
PÀLOlilAR
spécifications
GENERAL
Channels
Frequency Range
Frequency Control
Frequency Tolérance
Frequency Stability
Operating Température Range
Microphone
Input Voltage
Current Drain
Size
Weight
Antenna Connector
Semiconductors
Meter
Power Bandswidth
T R A N S M U T E R
Power
Modulation
Modulation Capability
Harmonie Suppression and
Spurious Emmissions
Ъ Ь
3 500
40 - AM/Single Sideband
26.965 to 27.405 MHz
Phaselock Synthesizer
±0.005%
0
002
±
.
-30°C to +50°C
Plug-in type dynamie with volume control
13.8V DC (Positive or Negative ground)
Receive 1.5A at maximum audio output
0.5A standby (no signal).
10 -6 /1 0 " L. X 8 " W. X 2-1/2" H.
6 lbs.
Standard American type
41 Transistors, 7 FETS,60 Diodes, 7 ICs
Illuminated, indicates relative power out
put and received signal strength
10.5 to 16V
: 4 Watts - AM (max. allowed by FCC)
12 Watts PEP-SSB (max. allowed by
FCC)
: High and low level Class B amplitude
modulation (AM)
: 95% Typical (AM)
: Better than FCC requirement
%
Advertisement
Table of Contents
Related Manuals for Palomar SSB-500
Summary of Contents for Palomar SSB-500
- Page 1 Ъ Ь PÀLOlilAR 3 500 spécifications GENERAL 40 - AM/Single Sideband Channels Frequency Range 26.965 to 27.405 MHz Frequency Control Phaselock Synthesizer Frequency Tolérance ±0.005% Frequency Stability ± Operating Température Range -30°C to +50°C Microphone Plug-in type dynamie with volume control 13.8V DC (Positive or Negative ground) Input Voltage Current Drain...
-
Page 2: Public Address (Pa) System
Frequency Response 400 Hz to 2.5 kHz - AM and SSB Output Impédance 50 Ohms, unbalanced Output Indicators Meter shows relative RF output power, Tx red lamp indicates transmit mode. RECEIVER Sensitivity - AM ,7^V for 10 db S/N Sensitivity - SSB ,25/iVfor 10 db S/N Selectivity 6 db at 4.2 kHz... - Page 3 PALOiïiAR 500 instruction manuał introduction The PALOMAR SSB-500 has been designed to provide a high level, trouble free performance of both AM and SSB modes in the Citizens Band Service which is comprised of the following frequency assignments: C H A N N E L F R E Q U E N C Y...
- Page 4 NOTE: This transceiver has been designed for use in Class D operation in the 27 MHz Citizens Band Radio Service. This transceiver is also designed to meet the Federal Communications Commission requirements applicable to equipment operating in Class D service, and is not to be used for any other purpose.
-
Page 5: Installation
Mounting and Connection The PALOMAR SSB-500 is supplied with a universal mounting bracket. The transceiver is held in the bracket by four bol ts permitting adjustment at the most convenient angle. - Page 6 The electrical noise may corne from several sources. Many possibilities exist and variations between vehicles requires dif ferent solutions to reduce the noise. Consult with your PALOMAR dealer or a CB Radio technician for help in locating and correcting the source of severe noise.
- Page 7 from the 50 ohms transmission line to the radiating element. In mobile instal lations (cars, trucks, boats, etc.), an antenna system that is non-directional should be used. A vertically polarized quarter-wave length whip antenna provides the most reliable operation and greatest range. The shorter, loaded type whip antennas are more attractive, compact and adéquate for applications where the maximum possible distance is not required.
-
Page 8: Controls And Indicators
CONTROLS AND INDICATO RS There are ten Controls and four indicators on the front panel of your PALOM AR SSB-500. A .CONTROL FUNCTIONS 1. OFF/ON VOLUME: Turn clockwise to apply power to the unit and to set the desired listening level. -
Page 9: Ind Ic A To R Functions
Channel 9 has been reserved by the FCC for emergency communications involving the immédiate safety of life of individuals or immédiate protec tion of property. Channel 9 may also be used to render assistance to a Mortarist. LSB-USB-AM MODE SWITCH: Selects mode of operation - Lower Sideband, Upper Sideband or standard AM: 5. -
Page 10: Push To Talk
1. Valid Class D Citizens Band equipment license shall be posted at the main control (fixed) station location. NOTE: Operation under a Temporary Permit, FCC Form 555-B, which is furnished with your SSB-500, is permissible while your regulär license application is being processed by the FCC. - 1 0 -... - Page 11 2. A properly filled out and signed identification card, FCC Form 452-C which is also furnished with SSB-500 , must be affixed to ail units. 3. Part 95 of the FCC Rules and Régulations, which is furnished with your SSB -500, must be read and understood.
-
Page 12: Maintenance And Adjustment
section III maintenance and adjustment The transceiver is specifically designed for the environment encountered in Mobile installations. The use of all solid state circuitry and its light weight resuit in high reliability. Should a failure occur, however, replace parts only with identical parts. -
Page 13: Parts List
PARTS LIST P a r t P a rt S y m b o l S y m b o l D e s c r ip t io n D e s c r ip t io n N o. N o . - Page 14 S y m b o l P a r t S y m b o l P a rt D e s c r ip t io n D e s c r ip t io n N o . N o.
- Page 15 S y m b o l S y m b o l P a r t P a rt D e s c r ip t io n D e s c r ip t io n N o. X - T A L 1 1 .2 8 4 2 M H z 2 3 7 R 2 5...
- Page 16 S y m b o l S y m b o l P a r t P a r t D e s c r ip t io n D e s c r ip t io n N o. N o.
- Page 17 P a r t S y m b o l P a rt S y m b o l D e s c r ip t io n D e s c r ip tio n N o . N o . N o .
- Page 18 S y m b o l P a r t P a r t S y m b o l D e s c r ip t io n D e s c r ip t io n N o. C 1 2 4 M y la r C a p 0 .0 4 7 C e r a m ic C a p...
- Page 19 A detailed list of troubles encountered must be enclosed as well as your name and address. Forward prepaid (United Parcel Service is preferred) to PALOMAR ELECTRONICS CORPORATION SERVICE DEPARTMENT Ш О Г Л А Я...
- Page 20 SCHEMATIC DIAGRAM...
- Page 21 SCHEMATIC DIAGRAM...
Need help?
Do you have a question about the SSB-500 and is the answer not in the manual?
Questions and answers