The Control Panel - Zanussi ZWD 1681 W Instruction Booklet

The Control Panel

1 Programme selector dial
The selector is divided into 5 sections:
• Cottons
• Synthetics
• Delicates
• Wool
• Special programmes
• Off = Reset programme/Switching the machine off
Position E60° corresponds to the ENERGY SAVING
programme, position
programme and position
Turn the dial clockwise or anticlockwise to select the
required wash and drying programme.
Before setting the dial to any position ensure that the
machine is switched off.
At the end of the programme the selector dial must
be turned to position Off.
Programme Option buttons
Depending on the programme, different functions can
be combined. These must be selected after choosing the
desired programme and before depressing the "Start
Pause" button.
corresponds to the drying
to "cold wash".
When these buttons are pressed, the corresponding pilot
lights come on. When they are pressed again, the pilot
lights go out.
If an incorrect option is selected, the corresponding
pilot light flashes for about 2 seconds and the message
Err is displayed.
2 "Spin Speed" button
Press this button repeatedly to change the spin speed, if
you want your laundry to be spun at a speed different
from the one proposed by the machine. The relevant
light will light up.
The following speeds are available for the different
fabrics.
• Cotton, linen: 700/900/1200 max 1600 r.p.m.
• Synthetics and wool: 700 max 900 r.p.m.
• Delicates: 700 r.p.m.
"Rinse Hold" :
When you choose this option, the machine will not
drain the water of the last rinse, so as not to crease the
laundry.
At the end of the cycle, the "Start Pause" button light
goes out, the "Rinse Hold" and the "End' pilot lights
are alight to indicate that the water must be drained. A
flashing zero will appears on the display.
To complete the cycle, choose one of the following
options:
•
Select programme "Drain":
The water is emptied out without spinning.
•
Select the programme "Spin":
Select the spin speed by means of the relevant button
and then depress the "Start Pause" button.
After emptying, the machine performs the spin cycle
at the speed previously selected.
6