Table of Contents
Advertisement
Before Use
In
on
Dismantle the transport
The transpo
on bolts are designed for clamping an -
vib
on components inside of the washing machine
1.
Remove the back cover.
2.
Remove the four bolts on the rear side and take out
3.
the back cover.
4.
Fill the holes le by the bolts with blanking plugs.
Note:
must face to outside, and you have to insert the
back cover from the two gaps as
Keep the transporta on bo
zers in a safe place for later use.
Adjus ng the feet and locking nut
There a
re adjustable feet under the bo om of the washing machine. Before
use, th
ey should be adjusted so that the machine is level. This will minimize
vibr ons and thus noise during use. It will also reduce wear and tear. We
recommend to use a spirit level for adjustment.Floor should be as stable and
flat as possible.
1.
2.
3.
inside,screw the bolts through the four holes on the board on to the tub firmly(Fig3).
and 4).Finally set the machine upright again.
on bolts
the back cover, the convex
shown in fig.5.
stabili-
6
2.
1.
3.
4.
Advertisement
Table of Contents
