The Control Panel - Zanussi jetstream ZJD12191 Instruction Booklet

Zanussi washer-dryer instruction booklet model number: zjd12191
Hide thumbs Also See for jetstream ZJD12191:
Table of Contents

Advertisement

The Control Panel

1 Detergent dispenser drawer
2 Mains-on light
This light comes on when the ON/OFF button is
pressed, and goes out when it is pressed again.
3 ON/OFF button
Press this button to switch the machine on. Press it
again to switch the machine off.
Programme Option buttons
Depending on the programme, different functions can
be combined. These must be selected after choosing the
desired programme and before depressing the START
PAUSE button.
When these buttons are pressed, the corresponding pilot
lights come on. When they are pressed again, the pilot
lights go out.
If an incorrect option is selected, the corresponding
pilot light flashes for about 2 seconds and the message
Err is displayed.
4 PREWASH button
The machine performs a prewash cycle at 30°C max.
The prewash cycle ends with a short spin at 650 r.p.m.
in programmes for C
OTTON
emptying of the water for D
This option is not available with the
programme/(handwash)
For use when washing heavily soiled laundry.
5 SPIN SPEED button
Press this button to reduce the maximum speed of the
final speed proposed by the machine for the selected
programme or to select position
and S
, and with
YNTHETICS
.
ELICATES
WOOL
and Miniprogramme
(RINSE HOLD) .
The light corresponding to the selected option
illuminates.
The following speeds are available for the different
fabrics:
• C
, linen: 500/700/900 max 1200 r.p.m.
OTTON
• S
and
YNTHETICS
500/700 max 900 r.p.m.
• D
and
ELICATES
500 max 700 r.p.m.
The light corresponding to the selected option
illuminates.
Rinse Hold
When RINSE HOLD option is selected, the last rinse
water is not emptied out, to prevent the fabrics from
creasing. When the programme has finished, the light
of the START PAUSE button and the pilot light
(DOOR) go out, the light
(
) are alight to indicate that the water must be
END
emptied out.
To empty out water there are 2 possibilities:
• Select programme
The water is emptied out without spinning.
• Select programme
spin speed by means of the relevant button and then
depress the START PAUSE button.
The water is emptied out and the laundry is spun at
the selected spin speed.
Attention! Before selecting programmes
, the selector dial has to be positioned on X
.
(cancelling).
The RINSE HOLD option CANNOT be selected for
the automatic Washing & Drying programme.
6 DAILY button
This option can be used for lightly soiled cotton or
synthetic items items in order to obtain a good
washing performance in a short time.
6
E
E
E
/(handwash)
WOOL
:
MINIPROGRAMME
and the pilot light
(draining):
(spin): reduce eventually the
:
(Drain) or

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Zjd 12191

Table of Contents