Advertisement
Important Safety Instructions
Before using this machine, read this section and follow the instructions to properly use
this machine.
Installation
◦ The unit should be used in a temperature and humidity-controlled room.
Keep the unit away from a place with poor ventilation, in dust or metal pieces.
◦ Do not place any objects on the unit.
◦ The place to install the unit should be vibration-free and the unit should be securely fixed. If the
unit is installed on the wall or on a high place, make sure to use the attached Mounting Bracket to
fix it securely.
◦ Do not install the unit close to high voltage equipments.
Handling
◦ Install a leakage breaker and safety breaker on the input power source and connect the ground to
use the unit.
◦ Connect to a power source of the specified voltage.
◦ Do not use with other drivers or devices except the models listed in this operation manual.
◦ If the protection circuit works due to overheat, stop operation immediately, pull the power plug
from the outlet and send it back to your HIOS distributor for repair.
◦ The unit may automatically stop in use when the protection circuit works due to overcurrent, etc.
Turn off the power switch once and turn it on in 5 seconds for restart.
If the unit stops while in screw fastening, make sure to check the torque of the fastened screw.
◦ Do not disassemble or modify the unit.
◦ Do not drop the power Supply or subject it to violent impact.
◦ Do not drag the unit by its driver cord or AC cord. Keep the cords away from foreign objects, oil or
something sharp.
◦ Make sure to grasp the plug section to disconnect the AC cord from the outlet.
◦ Turn the unit off and disconnect the AC cord from the outlet when the unit is not in use.
◦ IMPORTANT SAFETY INSTRUCTIONS-SAVE THESE INSTRUCTIONS.
◦ DANGER-TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK. CAREFULLY FOLLOW THESE
INSTRUCTIONS.
Selection of Power Supply Cord:
Use in U.S.A. - Use UL Listed detachable power supply cord, No.18AWG,3 conductors, flexible cord,
rated 10A, VW-1, 80°C, minimum 1.8 m, maximum 3 m long. Provided with a molded-on, non-polarized
attachment plug with a 15A, 125V (NEMA5-15P) or 15A, 250 V (NEMA 6-15P) configuration and a
molded-on connector which mates with the Power Inlet.
The following flexible cord type may be used: S, SE, SO, SP-3, SPT-3, ST,STO, SJ, SJE, SJO, SJT, SJTO, SP-2,
SPE-2, SPT-2, SV, SVE, SVT.
Use in countries other than U.S.A. - Use IEC60227 certified PVC flexible power supply cord, marked
H03VVF or H05VVF, 3C x 0.75 mm
2
, rated min. 10A, 250V
EN
Advertisement
