Specification; Operation - NX CEP00014 User Manual

3. SPECIFICATION

Input voltage:
Rated voltage outgoing:
Ambient temperature:
Charging battery types:
Rated power:
Rated output current:
Housing protection type:

4. OPERATION

A-1. Connecting Anderson connector
1. Connect the charger connector to the battery connector
2. Connect the mains cable 13 of the charger to the mains socket
3. The battery voltage display 9 shows the current battery voltage
A-2. Connecting clamps
1. Connect the «+» pole clamp (red) 14 of the charger to the «+» pole of the battery
2. Connect the «-» pole clamp (black) 15 to the «-» pole of the battery
3. Connect the mains cable 13 of the charger to the mains socket
4. The battery voltage display 9 shows the current battery voltage.
Should the connection of the clamps be swapped, the LED «reverse connection» lights up 5
B. Disconnect
1. Disconnect the appliance from the mains supply
2. remove the connector from the battery
C. Measuring stand by / battery voltage
After connection to the grid, the appliance is on Standby. The standby display 6 lights up. When the clamps
are connected, the battery voltage is shown in the LCD (voltage display 9). The segments of the condition
display 8 are empty.
If the voltage is below 3,8V or above 15V, the battery will not be charged. Th display briefly shows the
error message «Err». The appliance goes on stand by.
6V battery: If the voltage range of the battery is measured as between 3.7-7.3V, only programme 1 can
be selected.
12V batteries: if a battery is recognized in the critical voltage range of between 7.3-10.5V, the ap-
pliancechecks wether a fully charged 6V battery, or a discharged 12V battery is present. After pressing the
programme selection button 10 to select a programme, the appliance carries out a control measurement
for about 90 sec.
The display shows:
If after about 90 sec. between 7.3-7.5V are detected, a 12V battery is defective. The appliance goes on
standby.
220-240V ~ 50/60Hz
6V/12V
0°C to 40°C
- 6V lead acid battery 1,2Ah-14Ah
- 12V lead acid battery 1,2Ah-120Ah
- LFP 6.4V: to 1.2Ah to 14Ah
12.8V: to 1.2Ah to 120Ah
60W
0.8A/3.8A
IP65
3