Corbin HD-SR-H Quick Start Manual

Part Number:
Description:
Hollywood Solo, Pillion & Smuggler
Fitment:
Harley-Davidson Street Rod
Revision:
1
NOTE: We recommend the use of Loctite or similar
threadlock compound when assembling parts on your
motorcycle.
1. Your solo, pillion and smuggler should have arrived
with brackets preinstalled as shown in Figure 1 at right.
On the pillion and smuggler there is a rear bracket and
two tabs. On the front seat there is a hinge assembly
with latch pin.
2. Begin by removing your stock seats from the
motorcycle. Refer to your owners manual if necessary.
Remove the cable "seat keeper" from the seat basepan
and leave connected to your chassis. You will be using
this with the Corbin saddle.
3. Install the rear seat by sliding the seat into position
rear first engaging the tongue on your fender into the
bracket at the rear of the pillion pad.
4. Align the front tabs of the seat with the mounting
holes from the original seat and secure with the original
bolts as shown in Figure 2. Use the included nylon
washers between the metal tabs and your fender.
NOTE: All brackets on the pillion pad can be adjusted
slightly if needed.
5. Install the lock bracket onto your chassis as shown
in Figure 3 using stock and included hardware. Again
there is a little adjustment in this bracket if needed.
6. The hinge / latch pin bracket should already be
installed on the solo saddle so with the locking bracket
in place, you are ready to mount the front seat.
7. Remove the e-clips from the hinge pins on the
Corbin latch bracket and slide the saddle into place
engaging the hinge pins with your chassis. Do not
re-install the e-clips yet.
HD-SR-H, HD-SR-HP, HD-SR-H-C, HD-SR-SMUG
FIG 1
FIG 2
FIG 3