Top Panel - Hitachi EC701HP Operation Manual

Section 3 - Installation (ATSC EC701HP Transmitter)

3.5.3 Top Panel

Figure 3-13
Top panel with identifications
Description:
The following connectors are located in the top panel:
1,3- RF AFTER FILTER IN A / RF AFTER FILTER IN B
Function: Measurement point of the signal after the filter
Type: N Female
2- GPRS ANTENNA IN (optional)
Function: Antenna input for the GPRS module
Type: SMA Female
Manual Rev. 0.0 - March 2018
1 2 3
4 5
6 7 8
20
9 10
12
11 13
15
14 16
17
19
18
4,5- TURN IN A / TURN IN B (optional)
Function: RF Signal Input (VHF / UHF)
Type: F Female
6,8- GPS ANTENNA IN A / GPS ANTENNA IN B (opt.)
Function: Antenna input for the GPS module
Type: SMA Female
7- CONTROL PORT
Function: Equipament Managment
Type: RJ45
9,11- ASI / 310M IN 1A / ASI / 310M IN 1B
Function: Transport Stream input
Type: BNC Female
Impedance: 75 Ohms
10,15 - ETHERNET* STREAMING A / ETHERNET
STREAMING B
Function:Transport Stream over IP Interface
Type: RJ45
12,13- ASI / 310M IN 2A / ASI / 310M IN 2B
Function: Transport Stream input
Type: BNC Female
Impedance: 75 Ohms
14,16- ASI OUT A / ASI OUT B
Function: Sample ASI signal modulator
Type: BNC Female
Impedance: 75 Ohms
18- 10MHz REF. OUT
Function: Reference output 10MHz
Type: BNC Female
17,19- 10MHz REF. IN A / 10MHz REF. IN B
Function: Reference output 10MHz
Type: BNC Female
20- RF OUT
 Function: Transmitter RF output before filter
NOTE:
The other connectors identified are not used on this
equipment.
*Ethernet is a trademark of the Xerox Corporation.
3-17