Wiring Notes - Granite Devices Simucube 2 Accessory port Application Manual

D15 Connector Pinout
Figure 1 Accessory port connector pinout.
Pin numbering follows the connector as seen on the back plate of the device.
Pin Function
1 Reserved for future use
2 GND
3 Reserved for future use
4 Reserved for future use
5 Digital input
6 Analog input
7 Analog input
8 +5 V output
9 Reserved for future use
10 Reserved for future use
11 Digital input
12 Reserved for future use
13 Analog input
14 Analog input
15 GND

Wiring Notes

•
Maximum current from the 5 V output (pin 8) is 120 mA. Please do not exceed this.
Measure the power consumption of the devices before connecting them if not known.
•
Analog input voltage range is 0 – 5 Volts.
•
Use the D15 Connector Shield for only cable shielding.
o Do not connect the cable shield with GND pins.
•
A button / switch can be connected between pins 5/11 and GND. The inputs have internal
pull-up resistor and the inputs show as the first buttons in the DirectInput joystick
interface.
Notes and suggested usage
Leave unconnected
Leave unconnected
Leave unconnected
Joystick/sequential shifter button.
Accelerator/gas
Clutch
Maximum current 120 mA
Leave unconnected
Leave unconnected
Joystick/sequential shifter button.
Leave unconnected
Brake
Handbrake