Inserting The Batteries In The Remote Control; Remote Control Range - ohmex AIR 9000 CON Instructions For Use And Maintenance Manual

AIR 9000 CON
> > Inserting the batteries in the remote control
The appliance is equipped with a remote control.
To insert or replace the batteries (not supplied):
1. Remove the battery slot cover from the remote control rear part.
2. Insert the batteries (AAA 1,5V type).
RESPECT THE POLARITIES!
3. Reposition the battery slot cover.
If the remote control is not operated for prolonged periods of time, the
batteries will discharge and the remote control won't work; in this case,
replace the batteries with the new ones. The remote control batteries
must not be exposed to excessive heat such like sun rays, flames or similar.
☞ Do not leave the batteries (rechargeable) around, as there's
the risk that children or pets could ingest them.
☞
When necessary, replace both batteries. Using a new battery
and an old one at the same time could cause the loss of the
batteries themselves with consequent damages to the remote.
☞
Do not try to dismantle used batteries.
☞
If you're using non-rechargeable batteries, do not try to
recharge them.
☞
Do not short circuit or toss the batteries into fire.
Fire and/or explosion danger !
> > Remote control range
Do not submit the remote control to strong vibrations or shocks.
Store the remote control away from moisture and water.
If the remote control doesn't work after replacing the batteries, remove
and reinsert the batteries after waiting about 5 minutes.
USE
EN
95