Table of Contents
Advertisement
Transformers 50 VA-16 V and 52 VA-12/18 V
3. Assembly, connection and commissioning
Special note for transformer 50 VA-16 V:
!
The transformer 50 VA - 16 V is not a toy transformer!
It does not meet the requirements for transformers for
toys according to DIN EN 61558-2-7. Therefore do not use
this transformer in areas where children are unattended.
Installation
Place the transformer in such a way that it is secured against falling
down and the heat generated during operation can be dissipated to the
ambient air. The base plate of the transformer has holes to
accommodate fastening screws. Never screw screws directly into the
housing of the transformer!
Connecting the loads
When connecting the supply lines to the loads, make sure that the line
cross section is sufficient. Overloading the connecting cables can cause
overheating and fire hazard!
The terminals on the transformer are intended for connecting the
consumers. Press the pushbutton on the terminal and insert the
stripped connecting cable into the opening.
Ensure that the maximum total current / total power is not exceeded,
otherwise the transformer will be overloaded.
Output-
voltage
Max. total current
Max. total power
Transformer
50 VA-16 V
16 V
3,125 A
50 VA
Transformer
52 VA-12-18 V
Terminals 0 / 12 V: 12 V
Terminals 0 / 18 V: 18 V
2,9 A
52 VA
English
Page 5
Advertisement
Table of Contents
