Kelkay HENRI H5768F8RL Quick Start Manual

STAGE 1
Locate a suitable site for your Classical Finial Fountain.
Site should be level and provide a pleasing viewing angle.
NOTE: this is a tall vertical sculpture and care should be
taken to provide a level surface before assembly is started,
as a slight angle will be noticeable and can affect the
fountains water action.
STAGE 2
Locate the 7773 Extra Large Fern Base in the cente
of your site with the cord notch closest to your power
source. Level as necessary.
STAGE 3
Thread the 1"x 8" stand pipe into the 6772
extra large classical bowl. Pass the power
cord down through the stand pipe leaving
approx 10-12" of cord inside the bowl.
Install a rubber stopper over the power cord
and insert it into the top of the stand pipe.
The rubber stopper has a slit in it. Spead
the stopper apart at the slit and slide
the cord into the hole in the centre of
the stopper.
STAGE 4
Place the extra large classical bowl
on the extra large fern base while
passing the power cord down through
the base and out through the notch.
Centre and level as necessary.
STAGE 5
Connect the 42" x 1/2"NKG
(No Kink Tubing) to the pump outlet
with a snap clamp.
go to page 2 for STAGE 6
ADVISORY NOTICE
HEAVY ITEMS!
Please take care when
handling these items
IMPORTANT - WINTER CARE
Winter Ice build-up can cause damage to concrete statuary. Follow these tips to reduce winter weathering to your fountain:
• Disconnect power to pumps.
• Remove adapter from bottom bowl to open drains and let all moisture out. Keep drains open throughout winter.
• Place an absorbant material like burlap, blankets etc inside vases/bowls and cover all with a fountain cover.
• Do not allow snow or ice to build up on or against the concrete. Remove snow before it turns to ice. Do not use
salt or chemical ice removers as these may damage concrete.
H5768F8RL
Classical Finial Fountain
1 of 2
(8pc)