Advertisement
OPERATION
Read the ENTIRE IMPORTANT SAFETY
INFORMATION section at the beginning of
this document before set up or use of this
product.
1.
Select the desired size Hole Saw and either the
Large or Small Mandrel (not included with 68111
Hole Saw Set).
2.
NOTE: The 2-1/2" and 2-1/8" Hole Saws will
need to be unthreaded from one another.
CAUTION! Wear heavy-duty work gloves when
unthreading.
3.
The correct size Mandrel will fit exactly into the
Hole Saw.
4.
NOTE: The Adapter will be needed to attach the
Small Mandrel to medium size Hole Saws (such
as 1-3/8" and 1-1/2" sizes.) Carefully thread
the Adapter through the top of the Hole Saw
and then thread the Small Mandrel through the
bottom so that it screws into the Adapter.
5.
To attach larger Hole Saws to the Large Mandrel,
thread Hole Saw to top of Mandrel until mounting
holes at base of the Saw align with the mounting
tabs on Mandrel. Twist the bottom base of Large
Mandrel until the tabs extend into the Saw's
mounting Holes and the two pieces are securely
fastened together.
6.
Open jaws of drill chuck (not supplied).
7.
Place the Mandrel shaft completely into the
chuck and securely tighten the chuck.
68111 3-Piece Hole Saw Set
Record Serial Number Here:
Note: If product has no serial number, record month and year of purchase instead.
Note: Some parts are listed and shown for illustration purposes only, and are not available individually as replacement parts.
Page 2
68112 7-Piece Hole Saw Set
For technical questions, please call 1-800-444-3353.
8.
Holding the drill at 90 degrees to the stock, set
the Hole Saw on the stock.
9.
Press the drill's trigger switch to turn it on.
10.
If the drill is a variable speed type, start cutting
the stock slowly until the circle groove is made in
the stock. Then cut faster.
11.
When the hole is cut, release the trigger switch
and wait for Hole Saw to come to a complete
stop before removing it from the stock.
12.
Remove Hole Saw from drilling tool chuck.
13.
Remove Hole Saw from Mandrel and clean off
Hole Saw with a cloth. Place Hole Saw and
Mandrel back in carrying case. If a different
sized Hole Saw is needed, attach it to Mandrel.
14.
CAUTION! Verify all Hole Saws are returned to
case when work is complete.
15.
NOTE: The pilot drill bit should be replaced if dull
or broken. Always make sure the bit is securely
held in place after being reinstalled.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED
THE PARTS LIST AND ASSEMBLY DIAGRAM IN THIS DOCUMENT
AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER
OR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY
OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO
MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS
QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE
MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL
REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY
CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER.
THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS
OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT
PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF
REPLACEMENT PARTS THERETO.
68113 14-Piece Hole Saw Set
68111 68112 68113
Advertisement
