Chapter 2. Set up the dock
Install the dock
Use the accompanying ac power adapter, power cord, and Thunderbolt 3 cable to install the dock. The dock
supplies power to the computer when the dock is connected to ac power and your computer.
Enable the dock
To enable the dock when you connect it to the computer for the first time, do either of the following:
• Confirm the change when prompted if you have the administrator privilege.
• Restart the computer. When the logo screen is displayed, press F1 or Fn+F1 to enter the BIOS menu.
Select Config ➙ Thunderbolt(TM) 3 ➙ Security level ➙ No Security.
Update the device driver and firmware
Note: This is an optional operation.
The device driver is preinstalled on compatible Lenovo computers and the firmware is embedded into the
dock. The dock is ready for use after you connect it to your computer.
Lenovo recommends that you update the device driver and firmware whenever a later version is available.
You also can download the latest device driver and firmware from
http://www.lenovo.com/support/docks
.
3
© Copyright Lenovo 2019